Technology laying laminate flooring

Before the start laminate installation on the floor, you should make sure that the draft floor in the room is flat. This can be checked using a level. If the floors are uneven, they will need to be leveled, for example, using dry screed technology. And if there are small depressions and potholes, then proper laying laminate, they can simply be puttyed with a special mortar.

And so, you did the preparatory draft work, bought the necessary number of packages with laminate and you were taken to the object. Do not rush to immediately open the package and begin to lay it. By laminate flooring technology This flooring needs to be adjusted to the temperature conditions of the room. Let your packaging lie for 1-2 days indoors.

For installation of laminate flooring will require:
  • laminate,
  • laminate substrate
  • jigsaw or side saw,

  • hammer,
  • limiters
  • roulette,
  • square,
  • masking tape,

For proper laying laminate, spread the laminate substrate on the prepared base of the floor, and connect all the joints with adhesive tape.

It is better if it is cork, it will protect your laminate from moisture, add additional heat and noise insulation, and also hide minor irregularities of the floor.

Sticking with laminate flooring technology, begin to lay the first horizontal row of laminate from the corner of the room, butt the boards. Further alignment will be in this series is very important to collect it correctly. Having reached the last board in this row, measure its length and cut, taking into account the gap. Remember that for proper laying laminate, it is necessary to take into account the gap between the laminate and the wall at both ends of the row, the minimum is 8 millimeters.

Now the remaining piece of laminate from the 1st row, if it is at least 20 centimeters in length, will be the first board in the second row. Laying on the run saves material and makes drawing a laminate coating more spectacular. This laminate flooring technology makes end seams less noticeable.

If you want to make a 1/3 run of the board, then cut off 1/3 of the board and start the 2nd row with it. The disadvantage of this option is that there is no saving of laminate, a lot of material is spent on trimming.

The next row is going exactly the same as the 1st row.

Connect both rows, if necessary, beat them with a tack and a hammer.

Move the resulting surface from the floor to the wall and place the wedges, for the quality of them you can use the remnants of the laminate.

Also consider the irregularities of your walls when installing wedges. They may need a different thickness.

Next, the process laminate installation on the floor, occurs along the same lines.

When you reach the last strip, it may not fit between the wall and the finished surface of the laminate. Measure the distance between the wall and the finished laminate in several places. Pencil draw on the laminated stripes desired mark and saw off with a jigsaw. Lay as before, leaving the desired gap.

Watch the video: Lock N Place Laminate Flooring (March 2024).

Leave Your Comment